![]() The 350 vacuum line will need to be removed. The drive shaft yoke is the same on both transmissions. If you have a 350 transmission now with a nine inch tail the drive shaft will not need to be cut. D will be OD, 2 will be D and 2nd and 1st will be to the left and right of the 1. You will need a new 700R4 throttle valve cable and dip stick. If you have a 700R4 transmission and one of these two carburetors you need this part. With this kit getting the correct geometry is easy. Usually this part will correct a hard light throttle 1-2 shift. 700R4, adapter for a Holley or Edelbrock carburetors to install the throttle valve cable correctly. If you have a Holley or Edelbrock carburetor you need a carburetor adapter. The passing gear cable connection on the carburetor can be reused, if you have the original carburetor. The passing gear cable bracket on the motor can be reused. ![]() The cross member will need to be moved two or three inches. The drive shaft will need to be cut three inches. Swap a 350 transmission with a six inch tail to a 700R4 transmission : ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |